MKS 2200-200-1 for PJSC Krukovka Carriage Works
Compressors International has been designing and manufacturing the MKS for over 10 years, offering its customers full product support from the feasibility study and design cycle to the manufacture, commissioning and training of customer personnel in the operation and maintenance of compressor stations.
Compressors International fully shares the innovative approach to compressed air solutions and sets new standards in design engineering solutions for the Ukrainian industry. The implementation of the project for the supply and implementation of a compressor station at PJSC Krukovka Carriage Works was no exception. All innovative solutions have been successfully applied and assembled in the MKS 2200-200-1 Modular Compressor Station. This engineering solution does not require a separate room for the compressor station, it is mobile, and can be installed anywhere.
Compressors International has been designing and manufacturing the MKS for
over 10 years, offering its customers full product support from the feasibility
study and design cycle to the manufacture, commissioning and training of
customer personnel in the operation and maintenance of compressor stations.
Compressors International fully shares the innovative approach to
compressed air solutions and sets new standards in design engineering solutions
for the Ukrainian industry. The implementation of the project for the supply
and implementation of a compressor station at PJSC Krukovka Carriage Works was
no exception. All innovative solutions have been successfully applied and
assembled in the MKS 2200-200-1 Modular Compressor Station. This engineering
solution does not require a separate room for the compressor station, it is
mobile, and can be installed anywhere.
MKS have the following standard equipment
• Insulated metal all-welded case with technological openings and units for
equipment installation. Thermal insulation of the station - from
non-combustible materials.
• Internal cladding: walls, ceiling - galvanized profiled sheet, floor -
flooring from steel corrugated sheet.
• External metal protective ventilation grilles.
• The system of automated control of air supply / exhaust necessary for
cooling and operation of compressors with BELIMO electric drives or an analogue
(heat recovery system).
• Heating system - electric convectors with thermocontrollers (maintaining
the required temperature in the station room in automatic mode).
• Main emergency lighting
• Automatic powder fire extinguishing system (which performs fire detection
and extinguishing functions regardless of external power sources and control
systems), based on the signal-start-up device and powder fire extinguishing
modules MPP (r) “Buran-2.5”, according to NPB 88-2001.
• Manual fire extinguishing system - powder fire extinguishers OP - 4 (g).
• Power switchboard for powering compressors, auxiliary needs of the
container and controlling the ventilation system.
• Power and low-current wiring made in galvanized metal boxes.
• Pipeline system - connecting pipelines, pipe fittings, bypass lines of
the dryer and main filters, supports.
• Condensate drainage system
• Grounding system The station provides the necessary technological
openings and gates for repair and maintenance of basic equipment.
